Sstrhsrtj

I have setup a simple script like the below:

sshpass -p $password ssh -T $username@$ip_address -p 30007 <<- EOF > $save_file.pcap

    sh

    tcpdump -i eth5.1 -s 0 -n -v -U -w -

EOF



sed -i '1d' $save_file.pcap

The purpose of this script is so that I can run a tcpdump on a remote device, yet save the output into a file on my local machine (the remote device has very limited storage capacity, so this would allow me to obtain much large captures, as well as, of course, allowing me to setup captures on demand much more quickly).

The purpose of the sh and the heredoc is because by default, I am not dropped into the appropriate shell of this remote device. Issuing sh in the remote device gets me to the proper shell to be able to run my tcpdump, and this heredoc is the only method I've found to accomplish this task and still port the information back into my local file.

The issue that I'm running into is that once the script gets to the tcpdump section of this script, my terminal is given output like the below, and like I would expect to see when running a tcpdump into a file:

drew@drew-Ubuntu-18:~/Desktop$ ./Script.sh 

tcpdump: listening on eth5.1, link-type EN10MB (Ethernet), capture size 65535 bytes

Got 665

And of course that "Got" counter increases as more packets are captured and piped into my local file. Unfortunately, the only method I have found thus far to stop this and return my terminal is to initiate a CTRL+C.

The issue here is that this doesn't only stop the tcpdump on the remote machine, but it ends the script that is running on my local machine.

This of course means that nothing further in my script is run, and there are many tasks that I need to perform with this data past just the sed that I included here.

I've tried to instead set things up like follows instead:

tcpdump -i eth5.1 -s 0 -n -v -U -w - &

read -n 1 -s; kill $!

The thought process here is that my raw tcpdump information would still be posting to stdout, and therefor still be populating in my local capture file. However, it seems like when I tried to run a capture in this manner, with the &, it didn't actually let me post anything else into the terminal (not sure if just too much junk flying at all times or what). I even tried this locally and it seems like trying to run a raw tcpdump posting to stdout doesn't let anything else happen.

Based on this information, the only thing I can think of at this point is if there is some manner in which I can use the CTRL+C in order to close out of the tcpdump on the remote machine, but keep my script still running. Been searching for pretty much a whole day now without success. Any suggestions I can try? Or other methods of going about this that would be far more logical?